Electrical Equipment Services

---

Our engineering consultants perform electrical equipment testing on network switches and cables for wiremap, length, attenuation, NEXT, DC loop resistance, and return loss.

Our engineering consultants perform electrical equipment maintenance on power transformers both on site or in factory. These include type tests, routine tests, pre-commissioning tests, special tests, periodic/condition monitoring tests, and emergency tests.

Our engineering consultants perform electrical equipment maintenance on Power Distribution Units (PDU) to check for overheating in wiring, components, and connections. Additional testing is performed to ensure all electrical equipment in the system runs effectively.

Typically using infrared scanning, our engineering consultants perform electrical equipment maintenance on remote power panels (RPP) to detect failures in electrical equipment infrastructure.

Our engineering consultants perform electrical equipment maintenance on power whips to determine acceptance after installation, discover  deterioration of insulation, and verify splices and joints.

Our engineering consultants perform electrical equipment maintenance on fiber optical cables to verify good end-to-end transmission, detect defects such as macrobends, and determine correct panel location.

Our engineering consultants perform electrical equipment maintenance on system protection relays through visual inspection, insulation resistance tests, protection element tests, and microprocessor-based relay functional tests.

Our engineering consultants perform electrical equipment maintenance on metal enclosed busways including visual and mechanical inspections, voltage tests, and contact-resistance tests.

Gen set electrical equipment should receive regular electric testing such as load bank testing. Our engineering consultants will ensure that your backup generator will be operational and run effectively in the event that it needs to be used.

Automatic and static transfer switches must receive regular electrical equipment maintenance. Our engineering consultants perform visual inspection, insulation resistance tests, automatic transfer tests, and operation and timing tests on switches.

Our engineering consultants perform electrical equipment maintenance on Modular Electric Skids such as sensor and transmitter calibration, run process operation verification, and collect final documentation on the tested modules.

Our engineering consultants perform electrical testing such as system evaluation, risk assessment, field I/O testing, sequential test phase test and commissioning, integrated system program commissioning, wiring and cabling verification, input/output verification, and software verification on BMS & EPMS control panel electrical equipment.

Our engineering consultants perform electrical testing and maintenance such as contact-resistance testing, insulation-resistance, winding resistance, 2-point continuity check, voltage testing, and operational checks on in-rack power distribution electrical equipment.

Our engineering consultants perform electrical equipment maintenance such as such as steady-state load testing, harmonic analysis, filter integrity, transient response load testing, module fault testing, and battery rundown testing on UPS modules.

Our engineering consultants perform electrical equipment maintenance such as visual inspection, insulation resistance testing, dielectric withstand testing, contact/pole resistance, ground resistance testing, and surge testing on switchgear.